Our two-day Cmax Training; 201 covers Power Flame’s Cmax burner installation, start-up, commissioning, and troubleshooting. Majority of the class consists of hands-on training. Attending the Basic Combustion Class is recommended before enrolling in this course.

CMAX BURNER TRAINING OUTLINE:

1. Half day classroom covering combustion theory and related equipment used in the commercial burner industry.
2. Power Flame burner models and their modes of operation.
3. Demonstration and HANDS-ON setup of typical burner and boiler room components:
   – Understanding burner drawings and bill of materials.
   – Safety device setup and testing.
   – Common component electrical diagnostics.
   – Fuel supply and pressures.
   – Pilot testing and setup.
   – High draft Pilot setup.
   – Using data sheets for burner combustion documentation.
   – Oil nozzle adjustments and setup.
   – General burner maintenance.
   – Removal and maintenance of gun assembly.
   – Oil system components.
   – Dedicated Air atomization compressor setup.
   – Use of plant supplied air or steam atomization system in place of dedicated air compressor.
   – Mod motor setup.
   – Safe startup practices.
   – Flame zones and anchor points.
   – FGR setup and tuning.
   – Spud changing and adjustments.
   – Rope locations and adjustments.
   – Diffuser adjustments.
   – Outer gas adjustments.
   – Use of adjustable Pre-spinners.
   – Methods used for Low NOx burners.
   – Introduction to Director SCS (SLATE) control system.
   – Use of flow meters for determining high fire rates.