Cmax Burner Training; 201

Our two-day Cmax Training; 201 covers Power Flame’s Cmax burner installation, start-up, commissioning, and troubleshooting. Majority of the class consists of hands-on training. Attending the Basic Combustion Class is recommended before enrolling in this course.


  1. Half day classroom covering combustion theory and related equipment used in the commercial burner industry.
  2. Power Flame burner models and their modes of operation.
  3. Demonstration and HANDS-ON setup of typical burner and boiler room components:
    – Understanding burner drawings and bill of materials.
    – Safety device setup and testing.
    – Common component electrical diagnostics.
    – Fuel supply and pressures.
    – Pilot testing and setup.
    – High draft Pilot setup.
    – Using data sheets for burner combustion documentation.
    – Oil nozzle adjustments and setup.
    – General burner maintenance.
    – Removal and maintenance of gun assembly.
    – Oil system components.
    – Dedicated Air atomization compressor setup.
    – Use of plant supplied air or steam atomization system in place of dedicated air compressor.
    – Mod motor setup.
    – Safe startup practices.
    – Flame zones and anchor points.
    – FGR setup and tuning.
    – Spud changing and adjustments.
    – Rope locations and adjustments.
    – Diffuser adjustments.
    – Outer gas adjustments.
    – Use of adjustable Pre-spinners.
    – Methods used for Low NOx burners.
    – Introduction to Director SCS (SLATE) control system.
    – Use of flow meters for determining high fire rates.